Poslat na e-mail

Poslat na e-mail

Na zadaný email přijemce bude odeslán odkaz na tento produkt. Pokud máte dotaz k produktu, využijte helpdesk nebo navštivte sekci Kontakt.

Email příjemce:* 
Váš e-mail: 
Vaše jméno: 
Vzkaz: 


* Vaše jméno a email se zobrazí v odeslané zprávě společně s odkazem.

Sada modulů MQ-2, MQ-3, MQ-4, MQ-5, MQ-6, MQ-7, MQ-8, MQ-9 a MQ-135 + Pro Mini 5V Controller

TECHNICKÝ POPIS OD VÝROBCE:

MQ-2:
• detection concentration: 300-1000 ppm (combustible gas)

MQ-3:
• size: 32*22*27 mm
• main chip: LM393, ZYMQ - 3 gas sensors
• working voltage: DC 5V
• with a signal output instructions
 two-way signal output (TTL level output and analog output)
 TTL output signal for low level effectively (when the low output electric signal lights at ordinary times,
can be directly by single chip microcomputer)
 analog 0 - 5V voltage, the higher the concentration, the higher the voltage
 it has a high sensitivity and good selectivity to ethanol steam
 rapid response recovery features
• used in motor vehicles and other no drunken drivers homework personal on-site testing,
also used in other places of ethanol vapor detection

MQ-4:
 using high-quality dual-panel design, with power indicator and TTL signal output instructions
 with a DO switch signal (TTL) output and AO analog signal output
 TTL output valid signal is low (when the output low signal light can be directly connected microcontroller or relay module)
 the analog output voltage, the higher the concentration the higher the voltage
 methane, natural gas has better detection sensitivity
 there are four screw holes for easy positioning
 size: 32*20*22 mm
 with a long service life and reliable stability
 rapid response and recovery characteristics
• input voltage: DC5V power (current): 150mA
• DO output: TTL digital 0 and 1 (0.1 and 5V)
• AO output :0.1-0 .3 V (relatively clean), the highest concentration of voltage around 4V

MQ-5:
• suitable for home or industrial on LPG, natural gas, coal gas monitoring devices
• excellent resistance to alcohol, smoke interference
 using high-quality dual-panel design, with power indicator and TTL signal output instructions
 with a DO switch signal (TTL) output and AO analog signal output
 TTL output valid signal is low (when the output low signal light can be directly connected microcontroller or relay module)
 the analog output voltage, the higher the concentration the higher the voltage
 for gas, natural gas has better detection sensitivity
 there are four screw holes for easy positioning
 size: 32*20*22 mm
 with a long service life and reliable stability
 rapid response and recovery characteristics
• input voltage: DC5V power (current): 150mA
• DO output: TTL digital 0 and 1 (0.1 and 5V)
• AO output :0.1-0 .3 V (relatively clean), the highest concentration of voltage around 4V

MQ-6:
• suitable for domestic or industrial on LPG (liquefied petroleum gas), butane, propane,
LNG (liquefied natural gas) detection devices
 excellent resistance to ethanol vapor, smoke interference
 using high-quality dual-panel design, with power indicator and TTL signal output instructions
 with a DO switch signal (TTL) output and AO analog signal output
 TTL output valid signal is low (when the output low signal light can be directly connected microcontroller or relay module)
 0 ~ 5V analog output voltage, the higher the concentration the higher the voltage
 the propane, butane, LPG, LNG has a good detection sensitivity
 there are four screw holes for easy positioning
 sizes: 32*20*22 mm
 with a long service life and reliable stability
 rapid response and recovery characteristics
• input voltage: DC5V power (current): 150mA
• DO output: TTL digital 0 and 1 (0.1 and 5V)
• AO output: 0.1 - 0.3 V (relatively clean), the highest concentration of voltage around 4V

MQ-7:
• for home, carbon monoxide detection device environment
 suitable for carbon monoxide and gas detection
• detection of concentration: 10-1000 ppm CO
• loop voltage Vc: <=10V DC
• heater voltage Vh: 5.0V ±0.2V AC or DC (high)
• load resistance: adjustable.
• heater resistance RH: 31ohm ± 3 ohm (room temperature)
• heater power consumption PH: <=350mW
• standard test conditions:
• temperature: 20 degree ± 2 degree
• humidity: 65% ± 5% RH
• standard test circuit: Vc: 5.0V ± 0.1V; Vh(high): 5.0V ± 0.1V
• Vh (low): 1.5V ± 0.1V
 the analog output voltage, the higher the concentration the higher the voltage
 the carbon monoxide detection with better sensitivity
 there are four screw holes for easy positioning
 size: 32*20*22 mm
 with a long service life and reliable stability
 rapid response and recovery characteristics
• input voltage: DC5V power (current): 150mA
• DO output: TTL digital 0 and 1 (0.1 and 5V)
• AO output: 0.1 - 0.3 V (relatively clean), the highest concentration of voltage around 4V

MQ-8:
• suitable for domestic or industrial hydrogen leak on a monitoring device
• are not subject to ethanol vapor, soot, carbon monoxide and other gases interference

MQ-9:
 for home or factory gas leak detection device, suitable for carbon monoxide, combustible gas monitoring device
• can test carbon monoxide: 10 to 1000ppm CO
• combustible gas range: 100 to 10000ppm
• loop voltage Vc: <=10V DC
• heater voltage Vh: 5.0V ± 0.2V AC or DC
• heater resistance: 31 ohm ± 3 ohm (room temperature).
• heater power consumption PH: <=900mW
• temperature: 20 degree ± 2 degree
• humidity: 65% ± 5% RH
• standard test circuit: Vc: 5.0V ± 0.1V
• Vh: 5.0V ± 0.1V
• warm up time: more than 48 hours

MQ-135:
• MQ135 gas sensor is sensitive material used in clean air, low conductivity tin dioxide (SnO2) when the sensor is kept in their environment
• the contaminated gas, the conductivity of the sensor with the air pollution gas concentration increases
• using a simple circuit can be changes in the conductivity
• of the concentration of the gas is converted to the corresponding output signal
• MQ135 sensor for ammonia, sulfide, benzene vapor high sensitivity, smoke and other harmful gases
• measuring a variety of harmful gases

Součástí dodávky:
  • 1 ks MQ-2
  • 1 ks MQ-3
  • 1 ks MQ-4
  • 1 ks MQ-5
  • 1 ks MQ-6
  • 1 ks MQ-7
  • 1 ks MQ-8
  • 1 ks MQ-9
  • 1 ks MQ-135
  • 1 ks Pro Mini 5V Controller

Kontaktní formulář

Kontaktní formulář

Jméno: 
E-mail: 
telefon: 
Odesláním formuláře uděluji provozovateli webových stránek dobrovolný souhlas se zpracováním svých osobních údajů, které jsem ve formuláři uvedl. Tyto údaje mohou být použity výhradně pro komunikaci k tématu této zprávy a mohou být uchovány po dobu komunikace.

Mohlo by Vás také zajímat

Arduino Starter kit Senzory

Arduino Starter kit Senzory
Jedná se o soubor 37 senzorů, které jsou připraveny k připojení do mikrokontroléru, např Arduino nebo
Datasheety
 
Skladem 22
1 488 s DPH 1 230 bez DPH

Arduino laser modul červený 650 nm 5 mW 5 V

Arduino laser modul červený 650 nm 5 mW 5 V
Výkon 5 mW, napětí 5 V, červená barva laseru, vlnová délka 650 nm.
 
Skladem 12
80 s DPH 66 bez DPH

eses pohybové čidlo pro jednodeskové počítače

eses pohybové čidlo pro jednodeskové počítače
Úhel senzoru: < 100° tvar kužele, typ HC - SR501, napájení 4.5-20 VDC, klidový proud: < 50 uA
Videa Návody Datasheety Heureka
 
Skladem 43
75 s DPH 62 bez DPH

BME280 Modul Měření Teploty Vlhkosti a Barometrického Tlaku Precizní

BME280 Modul Měření Teploty Vlhkosti a Barometrického Tlaku Precizní
Napájecí napětí: 1,8 - 5V DC, rozhraní: I2C (až 3.4MHz), provozní rozsah: teplota: -40 až +85 ° C, vlhk
Videa Návody Datasheety Heureka
 
Skladem 17
315 s DPH 260 bez DPH

IIC I2C Gyroskop + Akcelerometr Modul MPU-6050

IIC I2C Gyroskop + Akcelerometr Modul MPU-6050
Tři osy gyroskop + tři osy akcelerometr, komunikační standard IIC, 16 bitový AD převodník, hmotnost 3 g
Návody Datasheety
 
Není skladem - na dotaz
126 s DPH 104 bez DPH

Hlídat dostupnost